Boost Tracer Especificaciones Pagina 1

TRACER 1206/1210/1215 ——Maximum Power Point Tracking Controller Installation and Operation Manual Thanks very much for selecting our pr

7 Connect load positive (+) and negative (-) to the TRACER load output as shown in figure 3-2. An in-line fuse holder should be wired in series in

8 Step 3：Solar Wiring WARNING: Risk of electric shock! Exercise caution when handling solar wiring. The solar module(s) high voltage output can cau

9 Figure3-5 System Wiring Review Step 6: Install Fuses Install a more than15 Amp DC-rated fuse in each fuse holder in the following order: 1. Loa

10 4 Operation 4.1 MPPT Technology The TRACER utilizes Maximum Power Point Tracking technology to extract maximum power from the solar modu

11 Figure 4-1 shows a typical current VS. voltage output curve for a nominal 12V off-grid module. Current VS. Voltage in 12V system

12 Figure 4-2 shows the sequence of the stages. Figure 4-2 TRACER MPPT charging algorithm ·Bulk Charge In this stage, the battery voltage has not

13 ·Equalize WARNING: Risk of explosion! Equalizing flooded battery can produce explosive gases, so well ventilation of b

14 ·Charging State Indicator The green LED indicator will light whenever sunlight is available for battery charging, the green charging LED will sta

15 4.4 Setting Operation . Load Control Settings 1. Dusk to Dawn (Light ON+Light OFF) When solar module voltage goes below the point of N

16 Press the Setting Switch, and the led will switch between load 1 timer, load 2 timer and battery type. Press the Setting Switch for 5 seconds w

TRACER Dimensions Specification Summary System Voltage 12V DC / 24V DC*1 Rated Battery

17 If either of the two loads is TEST MODE. The two loads will be TEST MODE simultaneously.

18 ·Load Short Circuit Fully protected against load wiring short-circuit. After two automatic load reconnect attempts (10 seconds between each attem

19 5.2 Troubleshooting Troubleshooting according to the following instructions: Faults Possible reasons Troubleshooting Charging LED indicator is

20 Note：If no charging LED indication when the connection is normal Measure the PV input voltage at the PV terminals, input voltage must be greate

21 6 Warranty The TRACER-MPPT charge controller is warranted to be free from defects for a period of TWO (2) years from the date of shipme

22 7 Technical Specifications • Electrical Description Parameter Nominal system voltage 12VDC or 24VDC Rated battery current 10A Battery voltage ran

23 • Threshold Voltage Description Parameter NTTV (Night Time Threshold Voltage) 5V; x2/24V DTTV (Day Time Threshold Voltage) 6V; x2/24V Table7-3 T

Contents 1 Important Safety Information ... 1 2 General Information ...

1 1 Important Safety Information Save These Instructions This manual contains important safety, installation and operating instructions for TRACER.

2 2 General Information 2.1 Overview Thank you for selecting the TRACER controller which represents advanced technology of our company. The

3 The features of TRACER controller are shown in Figure 2-1 Figure 2-1 TRACER features. 1 – Charging status LED An LED indicator th

4 2.2 Optional Accessories Remote Meter(Model：MT-2) The digital Remote Meter displays system operating information, error indications, and self-diag

5 Step 1: Choose Mounting Location Locate the TRACER on a vertical surface protected from direct sun, high temperature, and water. Step 2: Check for

6 NOTE: The TRACER is a negative ground controller. Any combination of negative connections can be earth grounded as required. Grounding is reco